Re: P6 V8 project: Alloy wheels fitted! time for bodywork
Hi Richard, looking very nice! arrow staight body n paint! I do like your front spoiler, temting I must say :wink: great feeling of actually getting & driving it once its finished or in my case driveable
Hi WillsMills 71, thanks for your comments, I love red, I was torn between that or black, Red was the winner, shows more detail & sets the chrome/ stainless trim off. I was reading your thread on the inner top repair, go for it! look at my pages say 5~7, I was a little dismayed but thought sod it, cut it all out & rebuild it! I'm lucky I have a garage so its easier said than done but you'll get there, as Richard said these cars are like a huge meccano kit, one bit a time! Good luck with it!
V8P6B, yeah the Cragars grow & grow on me! will leave the back but may lower the front a tad, will need 185/60/15 to avoid poss scrapping, get enough of that on the rear, well when its a real bumpy road....honest, may need to reduce to 195/15/60's.
There's quite a good selection out there in American wheels that now cater for the P6 5 on 5 stud pattern..check em out!
http://www.northhantstyres.com/main-wheel-page.htm
This is where I ordered mine from, very helpful!
http://www.raceways.co.uk/American_Wheels.htm