Search results

Hello all I want to find out how far can you skim a P6 2200TC head. Mine has a corrosion pit right on the bore lip position and it a bit deeper than i think it can be skimmed. Advice welcome.

Hello all. I have just fitted new small end bushes to my 2200TC con rods, Now the new piston pins are .012 larger than the bush, so I presume the bushes have to be reamed to fit. Is this correct ?

Hi all I have taken off my front springs from my 2200TC and they are a on the rusty side. I have a set like new from a late 2000. The 2000 springs have a red and a white stripe and the 2200 has just a white stripe. I know that two types of spring was used 170 and 150 but which is which or am I...

I need a P6 V8 front passenger side brake disk shield, mine has rusted away to nearly nothing.

Hi all I'm in the process of reconditioning a 2200 TC engine and have been looking for a set of conrod small end bushes. Apart from one supplier at a very high price, I cant find anything. Does anyone know where a set might be found at less than the cost of a kidney or if any other Rover bushes...

Hi all Anyone know where one might get a set of 2000 / 2200 small end bushes?

Hello all. We have just purchased a lovely 1974 2200TC P6, Having wanted a Rover P6 for a long time to tow our vintage caravan with, we purchased a Monza red 2200 last year. We were told it was immaculate and as it was 270 miles away from us we had quite a lot of photos sent to us. So we bit...

I'm doing a bit of work on my brakes and have read on an old post here that transit vented discs will fit on a v8 P6. Does any one know what you have to do so they will fit, machining ? different callipers ? etc etc . Any info will be appreciated .

.

Our new project REA 24R is coming along. Lots of nice rusty metal to play with and a knackered engine. All good fun ? Anyway if you guys would like to see what's happening go to our car's website here, http://our-vintage-world.weebly.com/ and go to the P6 section.

After working on the engine bay I will be spraying it and the inner wings. But What type of paint to use. I've seen a lot of gloss inner wings, but I believe this was not original, as a semi gloss was used by Rover. Is this still around or anything like it that will take the heat in an engine bay ?

Wanted a front n/s 3500 caliper.

I need a new intermediate chain wheel on my 2200, I can get the older 2000 two part wheel cluster, to replace my double chain wheel. Can anyone tell me if these are interchangeable ?

I have a set of Vandervell +10 thou con rod big end shell bearings for sale. Will fit 2000 / 2200 SC & TC. New old stock still in packet and box. Perfect condition. £75.00 or near offer, plus £5.00 postage.

Wanted a 2200 TC front wiring loom. Pm if have one.

I'm looking for a couple of 2200 TC wing / boot badges. P M me if you have any for sale

I'm putting a 2200 TC engine into my SC P6 and want to put in the TC round dial dash too. Is this a do-able job ? Would be glad of a few tips.

Wanted full dash for a Rover P6 2000 or 2200 TC, or a ammeter and oil gauge and rev counter.

Hi all, just registered here, purchased a nice P6 2200sc from eBay and here to pick all your mega P6 brains. :) The car is a two owner, the second owner purchased it in 1978, I got it from second owners wife. the car had done a thousand miles from a full restoration, then dropped a valve. The...

Wanted a 2200 engine or short engine, any condition considered. SC or TC