Search results

Hi all, I have just purchased a Borg Warner 35 for $50, it has made in Australia written on it, I was expecting a British box. Anyone have any info on it, I was wondering how old it is, apparently this trans is out of a 1975 p6, I have googled the serial number but not much luck. Any info...

Hey, I have access to a SD1 3500 Vanden Plas rusting away on a farm before it is taken away for scrap soon, anyone know if the Vanden Plas exhaust outlet manifold will fit a 1970 p6 3500 auto, was wondering about overheating and fitment issues and what the benefit would be, worth doing?

Hi all, I'm about to reassemble by manual steering box with my new seals and was wondering what type of grease to add to the ball bearings, the work shop manual says plenty of grease and then use EP90 oil, does it matter what type of grease to use?

Hey, can anyone help me with my Lumenition setup, I've installed it and its working well with the expected performance increase, smoother driving and less cranking and I’m very happy with it but the rev counter isn’t working. I connected the red wire to the fuse box, black wire to the chassis...

Hi, I have purchased a standard Lumenition ignition kit for my p6 3500 and have discovered that my coil is a low resistance Bosch coil that I can’t use with this kit, it needs to be 3.0ohm and above, all I need to do is find an appropriate coil, I have found at Aldon Auto 2 Lucas sports coils...

Hi, i was wondering if anyone recognizes my fuel pump or the kit i just bought, nothing fits from the kit, the shop says they sent the correct kit for a rover v8 fuel pump. There is no letters or numbers on my pump, its kinda on the small side. Is my pump like yours?

Hey, ive been cleaning this and that and pulling stuff apart to inspect and have got to the sump cover part, i pulled that off to clean the sludge and a good oil change and i commented to a mate that i could see all the way up thru the engine, he had a look under there and said my rover may of...

Hi, would anyone know if this vacuum advance unit will work with my Lucas 35D8 (41317) from simonbbc ? http://www.simonbbc.com/ignition-spares ... vance-unit

Hi, I've pulled apart my distributor to check, clean and lube and to replace my vac advance unit i bought from simonbbc, its a Lucas 35d8 (41317) on a 1970 rover 3500. I noticed the Cam springs are a different size, can anyone tell me if this is normal ? when i bought the car it had some small...

Hi everyone i want to buy new seals for my final drive but i dont know the name of them, ive been at wadhams searching but they dont have pics or much info My questions are... What would wadhams call it? Are they flat on one side and then rounded or are mine squashed, was thinking if they...

Hi, I've been Foraging underneath my rover and I decided to check the universal joints and greese them. I noticed i couldnt pull back the plastic guard on one outside axle to check, it cant go over this square metal thin block, not like the other side. My question is, are these metal things...

Just fitted 15x7 Superlites. Still alot of work to do for a WOF. Can anyone tell me if my rover is a series 2 or P6B or something else, I noticed a few people mentioning these models, I'm a bit confused.