Recent content by Bjk67

Has anyone got a spare carburettor spacer/insulator with the lugs and throttle rod from an early series 1 2000 for sale?

There’s no fixing holes attached and the rear end has snapped off where the ashtray sits

Thanks for reply, it’s the radio console and the handbrake centre console I need. Is there a great difference between them over the years? Do you have any?

I’m looking for a good radio and handbrake centre console for my 1964 series 1. Can anyone help?

Can you put a close up of how the bonnet stay rod attaches at the front and how it clips to close bonnet. Mine has been bodged and have no idea how it should be. Thanks

The ones I was going to do up had a tab half way up the tube but had corroded off. Haven't looked at the ones on my car yet to see the difference

This has probably been discussed before but are all front struts the same between models? I have two old ones from a 2200sc that I was going to overhaul to fit to my early 2000 that has Dunlop brakes.

How is the drivers side front wing?

Black series two flat pleat rear seats for sale. One cushion has small split and all need a good clean. Offers please and collection only

Thanks all, if it turns out ok box will be for sale

Without stripping it down is there any way to check for wear?

The number seems to be stamped over, possibly recon.

I've got a gearbox I bought years ago along with a rover v8 engine I think it's an LT77 type. Can anyone confirm?

Spotted in Denny, central Scotland red P6 mk2 NLD???L. Anyone on here?

The tabs are only there to hold the springs in place so won't make any difference. With the new disc being slightly shorter it won't make any difference as there is less chance it will foul on anything. As long as the hub fits in the flywheel and the cover there will be no problem.