1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Windscreen trim anomaly

Discussion in 'Bodywork & Interior' started by dmblbit, Jun 29, 2018.

  1. dmblbit

    dmblbit Active Member

    The stainless steel trim bits seem to be poking out more than they should in the top corner, leaving a gap between trim and rubber. Does any one know what's happened here please? Is this a trim issue or a windscreen fitting issue, or is something else more sinister going on?

    Thanks in advance

    Steve
    IMG_5245.jpg IMG_5247.jpg
     
  2. clive P62

    clive P62 Active Member

    Is it a new rubber?
    Unfortunately some don't fit nice in the corners on most cars I have seen.
    Still looking for a original one for mine.
    Clive.
     
  3. dmblbit

    dmblbit Active Member

    No - original rubber. I’m worried about water getting in.

    Although to be honest I avoid taking the car out in the wet. But that’s beside the point.

    Looks like a dismantle and rebuild job.

    Sigh.
     

Share This Page