Hensen1954
Active Member
My gearbox drive flange is 16 inches higher and 10.5 inches in front the the axle flange.
I dont want to drop the engines, etc down, and even if I did, they would not align all that well with the axle flange, so I am looking for ways to do basically a Z drive, in the space available. My best thoughts so far, are a cog on the back of the box flange, and a chain down to another cog, which will drive a short propshaft with a slide joint built in.
Anybody got one in their back pocket or another idea to save time and hair pulling ??
I dont want to drop the engines, etc down, and even if I did, they would not align all that well with the axle flange, so I am looking for ways to do basically a Z drive, in the space available. My best thoughts so far, are a cog on the back of the box flange, and a chain down to another cog, which will drive a short propshaft with a slide joint built in.
Anybody got one in their back pocket or another idea to save time and hair pulling ??