Search results

Ok to get at the linkage at this end do I just undo these bolts and lift so I can adjust the tension?

I know this sounds daft, but I've just done my heater box replace motor and matrix and cleaned the box up a bit. I took the temp and distribution levers out but I'm not sure how they slot back in from the dash. Do they slot in the furthest away from each other? Also I don't know why but the...

Ok old rear caliper wasn't working so off to wins and got a replacement . This has been put in but this caliper isn't working.. Has been bled several times etc. Anyone got a step by step of how this should of been done

Hi I'm looking for I'm not sure what I'm looking for :confused:. grommets and washers and covers that are used on the scuttle for the wiper arms . Not sure if I have the right names I only have a washer cover on one side no grommet if there is ment to be one I'm not sure. I tried looking at...

Ok I have just bought myself a p6 3500 1972. while driving home found out I only had side lights. these would go out when turning the light switch but come back on after a coulple of mins. I Don't get any main lights but am able to flash the full beam. Looked into the fuse box and found that...

I have just got myself a p6 3500 1972, and the speedo is only reading 35mph when I'm doing 50mph. The previous owner had replaced the gearbox with one from a sd1. How do I solve this problem would it b easier to replace the speedo from a sd1 or ?