Search results

Thanks Harvey. As the handbrake wont hold does it mean that I have to renew the cable? The only other thing that I did have a rear caliper replaced, would that of been the problem both calipers work as went through mot they were lieniant with the handbrake? Also if I had to renew the handbrake...

Ok to get at the linkage at this end do I just undo these bolts and lift so I can adjust the tension?

Thanks that is exactly what I needed to know about the springs thanks quattro

Where the levers go in the hole has 2 metal splines so do the levers go to the left of these or 1 left the other right wish I took a picture

I know this sounds daft, but I've just done my heater box replace motor and matrix and cleaned the box up a bit. I took the temp and distribution levers out but I'm not sure how they slot back in from the dash. Do they slot in the furthest away from each other? Also I don't know why but the...

:) thanks Harvey

Problem solved his 30 years of experience helped. The caliper had been knocked in transit and something moved inside the caliper which is now sorted and been put back now on car phew!

my mechanic is doing it and has just called me to say its not working is why I'm trying to find a step by step to help him

Ok old rear caliper wasn't working so off to wins and got a replacement . This has been put in but this caliper isn't working.. Has been bled several times etc. Anyone got a step by step of how this should of been done

Thanks its where I got the part numbers. Was just making sure, I got the grommets and the washer from wins.

Hi I'm looking for I'm not sure what I'm looking for :confused:. grommets and washers and covers that are used on the scuttle for the wiper arms . Not sure if I have the right names I only have a washer cover on one side no grommet if there is ment to be one I'm not sure. I tried looking at...

Frustrated, but smiling I've got a P6.

Ok I have just bought myself a p6 3500 1972. while driving home found out I only had side lights. these would go out when turning the light switch but come back on after a coulple of mins. I Don't get any main lights but am able to flash the full beam. Looked into the fuse box and found that...

I have just got myself a p6 3500 1972, and the speedo is only reading 35mph when I'm doing 50mph. The previous owner had replaced the gearbox with one from a sd1. How do I solve this problem would it b easier to replace the speedo from a sd1 or ?