Hello people , I need some advice about the valve lift I found after the shimming.
According the manual, the valve lift should be 0.370 in ( 9.40 mm ).
I measured the valve lift and found an average of 0.428 in ( 10.89 mm ).
Is it too much ? Any possibility of the piston hitting the valves ?
I enclose a couple of photos to illustrate.
I will appreciate any comment.
According the manual, the valve lift should be 0.370 in ( 9.40 mm ).
I measured the valve lift and found an average of 0.428 in ( 10.89 mm ).
Is it too much ? Any possibility of the piston hitting the valves ?
I enclose a couple of photos to illustrate.
I will appreciate any comment.