keynsham1
Active Member
I have just tried fitting my rear seat squabs and backrests. I have the original squabs which are of early ambla boxpleat design. My car is a 1970 Nada 3500S but I believe that these use the same seats that were used in the early 3500S cars. I have some second hand backrests which seem to fit perfectly, but at the outer edge at the lower corners where the backrest screws to the rear wheelarch area, I have a gap between the squab and the backrest of around 3/4" when both are fitted correctly. The center and inner edge of the seat fit fine. Are the seats different for early and late series 2 cars?