After 50 miles a new rear wheel bearing failed - one roller is mashed up - more than likely something I done. However close inspection of the tail on the drive flange part of the hub reveals it dont look very smooth so maybe that had some "bearing" on the problem.
Perhaps I should fit another flange, but does this mean I need a complete bearing and drive shaft assembly?
Not ordered another bearing just yet as had minor sugery on finger mid week and need to wait a week to avoid unnecessary strain on wound....(dam rose thorn got stuck in MAY!)
Perhaps I should fit another flange, but does this mean I need a complete bearing and drive shaft assembly?
Not ordered another bearing just yet as had minor sugery on finger mid week and need to wait a week to avoid unnecessary strain on wound....(dam rose thorn got stuck in MAY!)