I'm looking to fit my recently acquired Rev Counter to my 1970 V8. I ask, before I take all the dash apart, is there any existing wiring for this tacho present on the car, say behind the strip speedo or does the wiring need to be made up?
If the wiring needs to be made up, does anyone know what needs wired to where?
I believe that the spade connector on the back of the Smiths Tacho is the 12v supply from the ignition, then there are two bullet connectors, male and female. I assume one goes to the coil at the positive? Is this the male or female? And where does the remaining bullet connecter wire to?
thanks in advance,
Fraser
If the wiring needs to be made up, does anyone know what needs wired to where?
I believe that the spade connector on the back of the Smiths Tacho is the 12v supply from the ignition, then there are two bullet connectors, male and female. I assume one goes to the coil at the positive? Is this the male or female? And where does the remaining bullet connecter wire to?
thanks in advance,
Fraser