oil gauge

M

marcus

New Member
hi not sure if this is right place, im tring to fit an oil pressure gauge to rosie 2000 sc manual, but were do i fix in the pipe on the engine block, is it put were the oil switch goes, if so were do i get a male connector from , as thats a female and so is the end off my pipe, sorry its not written in tech talk, but as you know im a low tech guy,
any help or picture (coz i love pictures lol)of were it goes would be very welcome :D
regards
marcus
 
You could fit the external oil pipe from a TC engine and then use the proper drilling on that in the same way as it's done on the TC's.
 
thanks for you help ive ordered the bits i need and im adding a volt meter to just so that i know wots going on
regards
marcus :D
 
You must log in or register to reply here.
Back
Top