Greetings from North Alabama USA
- Thread starter oldSchool
- Start date
May be rather easier to go the whole hog and overbore to accept standard 2200 pistons, which are readily available. Plenty of articles on here on that topic - have a go at using the "Advanced Search" function in the top banner and see how you get on. Any more questions there's lots of us here to help!
Welcome to the forum by the way!
Chris
Welcome to the forum by the way!
Chris
P6Rovers
New Member
I agree.
If you are needing 30 over thou, you might as well bore out to 2200 standard. Some machining of the con rods are required. Might as well replace the small end bushings at the same time. :wink:
Better low end torque.
Check the Forum archives for a wide discussion, as noted, previously.
Eric
If you are needing 30 over thou, you might as well bore out to 2200 standard. Some machining of the con rods are required. Might as well replace the small end bushings at the same time. :wink:
Better low end torque.
Check the Forum archives for a wide discussion, as noted, previously.
Eric