Flywheel from an SD1 on a P6 Engine?

oport

oport

Member
Hello fellow Rover drivers,

since i totally fell in love with the V8 engine in my P6, i am in the process of fitting a P6 engine in another MGB GT. I will couple this with an LT77 5-speed gearbox from an SD1. My question: Does the SD1 flywheel work together with the P6 engine? Does the starter motor for the P6 work with the outer teeth of the SD1 flywheel? Any information is appreciated big time because i have to decide if i buy a SD1 flywheel this weekend...

PS: I will use the standard SD1 clutch with this setup as well..

CU Olaf
 
It's a straight swap between the two. You'll need the SD1 spigot bush as well as the complete clutch.
 
Don't you love it when it takes just 5 minutes on a forum and you get a quality answer?
Thank you harvey, that was the information i was hoping for...

CU Olaf
 
You must log in or register to reply here.
Back
Top