2Diesels said:
Hi John there's one on ebay at the minute, Pilkie put a link on here yesterday but here it is again
http://cgi.ebay.co.uk/WEBASTO-TUDOR-PUL ... 18Q2el1247
If you go for it tell him not to cut the roof then that way you can simply screw it on complete
Regards Colin
Hi gosnell & colin.
gosnell,Look under P6 spotted!!
There is a problem just unscrewing and removing the roof,as I found you would have to remove the headlining section first!! which means removing the sunroof to do it!
Best solution was to cut the roof off complete 1/2 way down the door and screen pillars,keeping it all intact for very carefully stripping down in the comfort of your lounge,as I did!
Remove the roof off your car,if its a non sunroof roof! Then place the headlining section in the car,fit the roof panel loosely in place with plenty of new sealant,and lift the headlining into position with its wood framework,putting sealant around between the wood and roof joint! then put in a couple of screws at each side to hold it up!put the other screws in just a little the going round them gradually working round the hole and evenly tighten them up drawing the headlining wood frame up,to spread the load evenly! this is best done with 2 people,as the headlining is very delicate and easily ripped if you try it by yourself and slip!
If you already have a tudor webasto "must be the exact same one!!!" and you only want to replace the main folding section,and your headlining is good,then you could have the roof cut out of the main roof panel a few inches around it!!
