jonnydurex
New Member
finally getting round to sorting my brakes out!! was getting air in the system from either the master cylinder or the servo so seeing as i have a spares car with superb brakes i decided to change them both just to be on the safe side....master cylinder swap was straight forward but servo had same body but different vacuum housing...so the plan is to just swap the vacuum housing over.i`ve seperated both the units and found the one i`m replacing to be full of brake fluid,i`m guessing this isnt right as the one i know to be ok wasnt!!....this means there is a seal gone in there somewhere!!! but is it in the vacuum housing or the main workings? also both the gaskets are way beyond saving..can i use some instant gasket? if not where do i get one from???
thanx
jonny
thanx
jonny