Search results

Hi all, I am selling a pair of P5 or P6 V8 cylinder heads that were removed from my engine. They are in really good condition as far as I can tell. Check out my ebay sale. http://www.ebay.co.uk/itm/130857504028? ... 1586.l2649 regards paul

Hi All. I am new to this forum but already I have found a good deal of useful information and advice. Brilliant job. I am currently rebuilding an RV8 engine that is of unknown provinence. It is an early engine in 3.5 format with rope oil seals. The engine number does not exist any where it...

Hi all. Early RV8 rebuild. I wondered if I might ask a question about the rocker shafts and their orientation relative to the rockers. I have two rocker shaft assemblies that are in bits. I pulled them off the heads about 3 months ago and have now go round to cleaning them up and I think they...

For the curious amongst you all, I have an early RV8 in a Triumph Stag. It is much nicer than the Triumph V8 as far as I am concerned. Lighter, more powerful and easier to work on.I have tried to workout where this particular engine is from without success. The engine number is 56822635C and it...

Hi All, I am new to this forum but hope you will be able to advise me on a best course of action. I have an old RV8 P5 or P6 engine and I have rebuild the block. I was really lucky and it needed little work. A polish, hone and rings/bearings. I could quote you the engine number but it just does...