Search results

Re: Door & wing seals, num.plate panel, rear offside door Might have a nos door skin if any good?

What a great day!!!!! Nice to meet some of you and chew the fat,and to see some cars that mine will have to live up too. Thanks for all the effort put in by you all involved.See you all next year when i WILL have Christine with me!!!!! :D

Can someone give me a picture of the faun speed control at the box end so i can see what angle to fix my damaged and now repaired spline. ta

Sorry make it more clear i can work out where to put the end piece on spine as when its set the flap closes and the lever jams so no fan operation. ta

Rebuilding my heater box and as per normal splines gone on fan speed lever can work out how it works as the flap closes but then there is no movement for fan speed halp please guys/gals

Took wing off and o/s/r wing and underseald and painted suspension and noticed top link has a kink in it is this correct or should it be straight? ta

Fitted new kit in my clutch master yesterday and refuted to Car went to bleed system and now fluid coming through checked Checked the cylinder seems to be working ok but not Drawing fluid any help would be great Ta

all sorted i was an idiot

Help rebuilding a spare clutch master have removed circlip and used air in the pipe inlet/outlet yet pison will not come out is it on a twist lock or somthing? ta help please

Davos white 3500s on southampton road sat about 12.30 any one on here cus im only bishopstoke so my patch.

Fruits of my labour http://www.flickr.com/photos/61205769@N ... 260970017/

Could someone tell me should i have live on both sides of my screen or does the voltage drop as it goes across.

Sorry yes do have electronic ignition so cant work ut why only from cold the carbs were rebuilt not long ago.

My 3500s has just started to missfire from cold and hav no fast idle just seems to be chokeing not high idle cleand out dizzy and cleaned rotor/cap replaced plugs about 500m ago any clues. ta as always

Can you fit a passenger seat to the drivers side i see no reason that you cant oter tham the metal plate on the outside edge. ta

Pleas coul someone help me with what paint should i use on my inlet manifold. ta

I think i might be ablwe to help you i was talking to my exhaust supplier the other day and he has a stainless system that he was tucked up with a while ago.I looked at it as he does not know wht p6 its off but its not v8 (unlucky for me!!!).They are based in southampton but they have a depot...

Meant to say noise is like metalike like the clutch is over throwing.

Sorry to sound stupid but i dont know what you mean?

Just replaced clutch/rear main and spigot and i now have a noise with my foot to the floor on the clutch lift of about 1/2 inch noise goes but this only accours at 2500rpm ish any clues.

Any one give me a clue of book time for doing a clutch on 3500s.Job will be don on a four post ramp. ta

My engine seems to run cool on a normal run of 10 miles or so the gauge reaches the dizzy height of top of the white heater also rubish i believe down to this leave her running at idle temp goes up to high green and then fan comes in.I have put a new stat in of 82c any idears!!!.

Drivers seat in ambla in ebony box pleat.good condition required.

See if this works have not uploaded picture before.

What are the seats like and the colour?