Search results

When adjusting the tickover on the 2000 TC model, I have found it best to adjust the rear tickover screw ONLY. This will open both carb butterflies equally due to the positive linkage between the carbs, rear to front. However the front carb tickover screw is independant and has no...

When adjusting the tickover on the 2000 TC model, I have found it best to adjust the rear tickover screw ONLY. This will open both carb butterflies equally due to the positive linkage between the carbs, rear to front. However the front carb tickover screw is independant and has no...

Does anyone have experience of balancing twin SU's (HS8)using vacuum gauges on the manifold side of the carbs ? I have used a crypton balancer which goes over the inlets but with this I could only check one carb at a time and I am convinced that it had a choking effect on the carb being...

Does anyone have experience of balancing twin SU's (HS8)using vacuum gauges on the manifold side of the carbs ? I have used a crypton balancer which goes over the inlets but with this I could only check one carb at a time and I am convinced that it had a choking effect on the carb being...

Does anyone have any ideas why I am getting a greenish slime in both the crankcase breather pipe and from the rocker cover breather, (it looks very much like the gunge in the new anti smoking campaign adds, and is I suppose emulsified oil). The engine oil looks clean both on the dipstick and in...

Does anyone have any ideas why I am getting a greenish slime in both the crankcase breather pipe and from the rocker cover breather, (it looks very much like the gunge in the new anti smoking campaign adds, and is I suppose emulsified oil). The engine oil looks clean both on the dipstick and in...

Has anyone seen a 2000TC fitted with the original oil cooler ? was it a standard fitting on early 2000TC's or just a rare optional extra ? Any idea where I might get one and do I need additional oil pipes / adapters as well. (I have an oil cooler section on the bottom of my radiator but...

Has anyone seen a 2000TC fitted with the original oil cooler ? was it a standard fitting on early 2000TC's or just a rare optional extra ? Any idea where I might get one and do I need additional oil pipes / adapters as well. (I have an oil cooler section on the bottom of my radiator but...

Hello all, you may be interested to know that Classic Badges Tel 01527 522922 www.classicbadges.com have stock of new series II bonnet badges at £32.50 each. I have no connection with this company but have just purchased a badge and thought others might be struggling to find the same at a...

Does anyone know whether it is possible to remove & replace the rear selector finger at the gearbox end of the gearshift extension shaft, without removing the whole extension casting -. I remember all too well the desperate struggle I had years ago trying to undo the four bolts on top of the...

Does anyone know whether it is possible to remove & replace the rear selector finger at the gearbox end of the gearshift extension shaft, without removing the whole extension casting -. I remember all too well the desperate struggle I had years ago trying to undo the four bolts on top of the...

Does anyone know whether it is possible to remove & replace the rear selector finger at the gearbox end of the gearshift extension shaft, without removing the whole extension casting -. I remember all too well the desperate struggle I had years ago trying to undo the four bolts on top of the...

I have a set of "ROVER" chrome badge letters to fit to a very early series 2 2000TC. From what I have seen these fit along the very top edge of the boot lid. I can work out the horizontal spacing from pictures but how high up should they be. Could anyone advise the height from the top edge of...