TreeVee's latest activity
-
TreeVee replied to the thread P6 Pinion and rack PAS.There is a swedish version too: https://vb-pim-bucket.s3.eu-north-1.amazonaws.com/assets/manuals/7780216f-06e1-458e-9bd8-c0bf5e0f3752.pdf -
TreeVee replied to the thread P6 Pinion and rack PAS.Hej Per, I sourced a DCE Microsteer system for my P6 3500 LHD (Sweden) which I had to do the installation bits for. I made a report...
-
TreeVee replied to the thread Neatening the boot lining.My previous owner(s) had patched up what remained of the rubber with contact glue to body. A sore sight!
-
TreeVee replied to the thread Neatening the boot lining.Yes, you should be really satisfied! Putting the sidewall lining on panel is a great improvement over the original "curtain" hanging...
-
TreeVee replied to the thread Neatening the boot lining.Hi Paul, I was looking for a narrower wheel with the same 5x127 mm bolt circle and found that a Chrysler Voyager minispare could fit...
-
-
TreeVee replied to the thread Neatening the boot lining.It sure looks neat! The matching does not look too bad considering that so much of the original velvet like carpet remains that a...
-
TreeVee replied to the thread Neatening the boot lining.I can't help you. A previous owner made a custom stainless steel battery box that had the spacer in it but, like you, I did not...
-
TreeVee replied to the thread Neatening the boot lining.I agree - looks fine. I used 1.5 mm aluminium and automotive rubber backed carpet both of which could not be stretched to follow a...
-
TreeVee replied to the thread Neatening the boot lining.Problem with the RH side panel is that, if single curvature, it cannot easily be made deep enough to clear the battery well and allow...
-
TreeVee replied to the thread Neatening the boot lining.I am in Sweden - hence our "near side" is to the right!
-
TreeVee replied to the thread Neatening the boot lining."Near side" is left hand side in OZ - right? The bulge, as seen in the trimmed panel and barely visible in the aluminium panel behind...
-
-
TreeVee replied to the thread Neatening the boot lining.Thanks! Check my thread "Boot interior" May 3, 2023, in this forum for more details including space saver (width only!). P-G
-
TreeVee replied to the thread Neatening the boot lining.Hi, I made 1,5 mm aluminium panels and trimmed them with automotive grade textile carpet. The boot floor is 12 mm plywood. And fitted a...
-
