Recent content by Rover2000nut

Is anyone running a GM t5 5speed gearbox in their 3500S P6……I think i can get a bell housing but what other issues am i looking at……i'm sick of the SD1 5 speed i put in my 3500S Nada……the shift is horrid and i have the dreaded whine also Thanks Bill Robertson

Hi Ian...... any chance there are any non air fascia plates....sorry to hear you sold up Bill Robertson

Before we start i'm in Ontario Canada so they will have to be shipped although there is not much of any weight but it would be bulky...Hopefully someone over here will take the whole bunch if not someone over ome would take it all Head gasket set for Rover 75 Manifold gaskets Clutch pedal oil...

Thanks guys i'll keep looking 69 2000TC 71 3500S NADA 5speed manual...air (no worky) 71 3500S NADA auto

Thanks ...now where can you find new heads

are the mirror heads the same......my stems are good....can i maybe find new mirrors just Thanks Bill

I need a pair of good or new if possible Wingard mirrors for my 3500S.....any ideas..i seen a pair on Ebay and my puter froze so i lost those.....thats the first set i have seen in ages Thanks Bill

i'm looking for NOS 3500S badges for the front grille and rear trunk(boot) for a NADA 3500S......any leads Thanks Bill

Thanks guys .....i'll try these suggestions out when i can get back out there

Thanks for the info James........I'm an electrical idiot here so bear with me...........the low tension wire you talk of is it the pos or neg side of the coil.......i pulled battery out and disconnected the + and - coil wires to look at them.......they are well wrapped and i split a bit to see...

Thanks James.....how do you take the tach out of the circuit

NO i'm in Canada.....I run high octane fuel.....10.5:1pistons .the miss is from idle to 2000 rpm around.....it just started last week......was fine on our outing the week before......i run an inline fuel filter which i have changed......i believe it isn't fuel related as evidenced by the...

My 2000 TC has developped a miss at low revs usually.....when the miss is occurring the tach jumps all over........I've so far changed the coil...no change........then changed the condensor....no change........i'll try the points, rotor and cap next.....(I have a wonky back so can only do a...

I'm looking for a MOMO boss kit( steering wheel adapter) for my 3500S or similar that will adapt a MOMO steering wheel to my P6 ...........i also need a good leather wrapped center console for my 3500S but barring that i'll use a 2000TC plastic console.........i'm referring to the tunnel...

are your hubs the regular hub or the Magnum 500 hubs that came on some 1967 cars but maybe only on the export versions.....the bolt pattern size is different