jp928's latest activity
-
jp928 replied to the thread Water leak at fuel filler grommet ?.And if the hose has been glued on, as mentioned in the book? Gets a bit difficult? -
jp928 replied to the thread Water leak at fuel filler grommet ?.Thanks. Still open in my mind is - does the opening cap assembly come off without cutting or removing the big hoses? The parts book...
-
jp928 replied to the thread Water leak at fuel filler grommet ?.Care to elaborate on that please? So far all I have been able to confirm is that pouring some water over the filler cap it runs straight...
-
jp928 replied to the thread Water leak at fuel filler grommet ?.Excellent, hopefully easy and quick!
-
jp928 replied to the thread Water leak at fuel filler grommet ?.Thanks Bernd! So if I understand you correctly removal of the filler cap will give me access to the grommet? I doubt there is water in...
-
Was out in the wet this morning - probably a first for me and the car. Found some water in the boot on return, and with a bit of...
-
jp928 replied to the thread lower tensioner.I have long ago seen a strange rattle up front caused by the lower chain guide breaking its mountings and falling into the sump.
-
jp928 replied to the thread P6B S Project Car.I routed the flex pipe down to the area behind the LHS lights and windscreen washer. Yes, will check the plugs soon.
-
jp928 replied to the thread P6B S Project Car.Went for a little run today. Found a non-powered temp gauge driven by a thermocouple, so I clipped the gauge wire under a wiper, and put...
-
jp928 replied to the thread P6B S Project Car.I found an old P6B air cleaner casing - painted a dreadful red, pretty scrappy condition. Cleaned it back to bare metal, painted it...
-
jp928 replied to the thread Broken oil pump idler.Why not fit an SD1 front cover, with its bigger pump WYAIT?
-
jp928 replied to the thread Broken oil pump idler.Check the bearing size, usually marked on the back of the shell if they are not std. The scoring/scratches look like dirty oil at some...
-
jp928 replied to the thread Engine wont rev above 3000rpm.I have never found anything in the specs regarding fuel pressure or flow. These are critical figures in injected systems, and pretty...
-
jp928 replied to the thread P6B S Project Car.Note that my bumper mounts are part of a locally made towbar, which is seen on many P6 down here. I tried measuring all sorts of parts...
-
jp928 replied to the thread Engine wont rev above 3000rpm.Had a mini once that was like this - would only pick up if you opened the throttle VERY VERY gradually. Final fix - points plate in the...