colnerov's latest activity
-
colnerov replied to the thread Brake Servo rubber hose - replacement.If there's a vacuum in the pipe, although not a true vacuum which depends on throttle position. Then it's going 1 bar max, subject to... -
colnerov replied to the thread P4 was misfiring a bit and now won't start.The filter should go after the sedimenter bowl, the sedimenter bowl takes out the larger pieces and any water, and the filter then takes...
-
colnerov replied to the thread Broken oil pump idler.Judging by the engraved 'T' in a circle, are they aftermarket gears?
-
colnerov replied to the thread dash lights.The Otter switch is the triangular switch on the inlet manifold. The most likely biggest hurdle will be the bolts that hold it in...
-
colnerov replied to the thread Brake Servo rubber hose - replacement.Presumably you know to use vacuum hose and not ordinary hose? Vacuum hose is braced against collapsing, whereas ordinary stuff isn't.
-
colnerov replied to the thread Engine wont rev above 3000rpm.Is this lack of power a new thing? Has it been better previously? Those compression readings do seem a bit low, is it a low compression...
-
colnerov replied to the thread Oil pickup changes.The deep part or well of the sump on P6b is in the middle of the sump, the well on the SD1 is at the rear. There will be more leverage...
-
colnerov replied to the thread Differential removal - is workshop manual correct ?.'Lower port'? It is usual, but I would agree it's questionable, so that it's easier to access. However, I would be tempted to pipe it to...
-
colnerov replied to the thread Differential removal - is workshop manual correct ?.Replace the brake pipes while it's out, it's a lot easier on the floor than when it's in the car. ;)
-
colnerov replied to the thread P6 Pinion and rack PAS.I can see that he intends to use two idler arms so the rack will go across by the bulkhead. He needs a rack from a car that has it...
-
colnerov replied to the thread P6 Pinion and rack PAS.Or you could fit a PAS steering box, The pump may be easy or involved depending on whether it's 4 cylinder or V8. Electric pump is also...
-
colnerov replied to the thread Electric Fans.I would suggest you need a bigger alternator to cover that additional 40A load.
-
colnerov replied to the thread P6 Wiper blades.Just measure the length of the blade and go into your local or online motor factors, they come with a variety of fittings to attach it...
-
colnerov replied to the thread Cam Timing.It sounds like it's running on only one carb. When you operate the throttle do both carbs open, not just the linkage but the butterflies...
-
colnerov replied to the thread Differential removal - is workshop manual correct ?.Hi, Yes it will. Coincidently, it was the same job I did on my first P6b, occasioned by a previous owner letting the diff run out of oil...