Thanks for your advise i am looking at a gasless one in machine mart for £111 but it only goes up to 85 amps will this be powerful enough to weld the new sills on?
Hi all
I'm looking for a bit of advice and i know that everyone has different views and feelings on this.
I need to do some welding on the old beast but i dont know what welder to buy ARC/MIG i can use both but have never welded a car before.
Also what sort of amps are needed as i see that...
I think its going to be a job for the future i am going to deal with my brake problem first.
Does amyone know where to get so front/rear calipers?
My are so siezed i cant move them!!
I think its going to be a job for the future i am going to deal with my brake problem first.
Does amyone know where to get so front/rear calipers?
My are so siezed i cant move them!!
Yeah thanks that was a very good spot by you :D
I was wondering if anybody shows there cars at all?
If you do are any of you going to the woking car show on the 17th june?
Yeah thanks that was a very good spot by you :D
I was wondering if anybody shows there cars at all?
If you do are any of you going to the woking car show on the 17th june?
The car has been sitting for about 4 years.
The front brakes so well siezed i had to knock the old pads out as the wouldnt move.
I will try WD40 on the front brakes and see if that works.
The car has been sitting for about 4 years.
The front brakes so well siezed i had to knock the old pads out as the wouldnt move.
I will try WD40 on the front brakes and see if that works.
i am not sure yet as i have taken the front brake pads off at the moment and found that they where siezed so i guess i may have to overhaul the whole braking system
i am not sure yet as i have taken the front brake pads off at the moment and found that they where siezed so i guess i may have to overhaul the whole braking system
I am aiming to do 99% of the work myself like you say a challenge.
I think i mshould be ok with most of it.
I will need to replace the brakes before i do anything else i think.
Does anone know of a supplier for back and front brakes.
Once i have done the brakes i will be able to test the car...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.