Which way to go.....

roverp5Bcoupe said:
Very nice build and nice result! The Rover V8 engine's can look so nice when done properly like you did. Do the elbows have an additional way of fitting or are these only held by the O-rings?
Peter
Click to expand...
Thanks, Peter.
Must say it's been enjoyable building it up.

I held the elbows in position horizontally then drilled through both elbow and adaptor (at the rear) to take a roll pin, which stops the elbows sagging. It does mean I have to take both the elbow and adaptor off together, but that's no hardship.

Stan
 
Fabulous work Stan !! The photo spread is wonderfully helpful way to illustrate progress and due process.

Ron.
 
You must log in or register to reply here.
Back
Top