westOz74P6B
Member
Is someone able to provide the measument for the sleeve shank diameter for the wheelnuts which suit the rover alloy wheels, I see that Wins do a set of wheel nuts to suit alloys fitment to P6 (7/16" thread), but was wanting to know what the shank diameter is (and shank length as well if whoever can oblige),
Cheers,
Scott
edit, would you believe it, I just tried a 13mm socket in the hole of the rover alloys and it was a very neat fit, that measured 0.700" (17.78mm), so, what I then need to confirm is, is this size hole unique to the rover alloys, therefore no point trying to source some wheelnuts other than those available from Wins?? because other aftermarket ones I've tried so far are a bit on the small (shank dia 0.681") side.
Cheers,
Scott
edit, would you believe it, I just tried a 13mm socket in the hole of the rover alloys and it was a very neat fit, that measured 0.700" (17.78mm), so, what I then need to confirm is, is this size hole unique to the rover alloys, therefore no point trying to source some wheelnuts other than those available from Wins?? because other aftermarket ones I've tried so far are a bit on the small (shank dia 0.681") side.