Hello there
While poking around under the rear seat squab today I found that the well had some surface rust. After some prodding with a screwdriver to test for strength, while most of the well is intact I found a small hole in the wall of the well, towards the rear of the car, such that I can poke a finger through into the box section running longitudinally along the length of the car (not the sill, but the section that runs parallel to the sill).
The hole is about the size of a 10p piece, so not too large, but knowing the p6 is rather notorious for rust in this area I wondered if anyone has tackled repairs here, and whether anyone can offer advice. The rest of the car is reasonably rot free and sound and I'd like to repair the hole.
Anyone done repairs in this area?
While poking around under the rear seat squab today I found that the well had some surface rust. After some prodding with a screwdriver to test for strength, while most of the well is intact I found a small hole in the wall of the well, towards the rear of the car, such that I can poke a finger through into the box section running longitudinally along the length of the car (not the sill, but the section that runs parallel to the sill).
The hole is about the size of a 10p piece, so not too large, but knowing the p6 is rather notorious for rust in this area I wondered if anyone has tackled repairs here, and whether anyone can offer advice. The rest of the car is reasonably rot free and sound and I'd like to repair the hole.
Anyone done repairs in this area?