Rivet size...

PeterZRH

Well-Known Member
For the A pillar trim and the aluminium retainers for the outer body seals (the stapled rubber strips).

Whatever it is, it is less than the smallest 3mm from the local DIY.
 
Thanks Vern,

I'm confused - 1/8 is 3.2mm but the 3mm rivet was too big for the hole in the A-pillar. Mind you it is a NOS item, so was the hole drilled out when fitted? Strange.
 
That would be my guess Peter. I just did a windshield and the vertical seals this fall, and had no problems with hole size. I only drilled the rivet heads off in removal, so I hadn't opened any of the holes up either.

Yours
Vern
 
Back
Top