removing fuel pump valves

#1
Got to overhaul my fuel pump: Haynes manual says scrape off the burring holding valves in place, how to do this isn't very obvious to me on inspecting my pump. Any tips?
 

cobraboy

Well-Known Member
#2
If you look closely at the rim of the valve you should see where the casting has been staked to hold the valve in place - in three or four places.
It is these areas you need to scrape off with a sharp scraper or a sharp file tang to enable you to lever the valve out.
You then stake the new valve in different locations using a small punch.
 
Top