PAS pump seals replacement

#1
Hi all

PAS pump on 1971 P6B was leaking so I got a seal kit from Wadhams and removed pump and have replaced all seals apart from the shaft oil seal that sits between a retaining cap and the shaft bush.

how do you remove the old one and replace with the new one? I'm stumped.

Any and all advice welcome

Thanks

Richard
 

jp928

Active Member
#2
Whats the issue? No access? With metal bodied seals common practice is to carefully drill a 1/16" hole in the metal, drive a self tapper into it, pull with vice grips.
 
#3
Whats the issue? No access? With metal bodied seals common practice is to carefully drill a 1/16" hole in the metal, drive a self tapper into it, pull with vice grips.
thanks.... managed to get enough wiggle room to punch it out with a drift. replaced with non capped seal

thanks again

Richard
 
Top