Parts Available

The Rovering Member

Well-Known Member
Gentleman & any ladies present.

Practicality has finally caught up with me in that I have been given notice to quit my storage/workspace. Therefore I have various bits & pieces to dispose of, including a car or two. Infomation on those will follow in a few days.

For now I have some items which I hope can be made use of by others, as I would not like to be throwing worthwhile things in the proverbial skip. Have a look & register any interest on here or by PM. Just offer what you think is half-reasonable as the aim is more to find good homes for stuff. A few beer tokens will of course be gratefully received though. ;)

A NOS downpipe for a manual 2000/2200:



A decent S1 bootlid, will fit S2 too of course:



A decent S1 2000 bonnet:



Some bits & bobs:



I'll list more as I dig it out but I'm there pretty much all the time until the end of next week so if you can get to Ilford & want to pay a visit for a little root-about then PM me.

On the plus-side, tomorrow morning I'm going to look at a workshop that my brother knows is becoming vacant in the next few weeks. Slightly more expensive & a bit less space but not quite so ramshackle & in a more rural location. Room for four cars but that's full capacity so three maximum would leave workspace. Not definite yet but fingers crossed. I do want to declutter myself though even if I get it so there is plenty to go. Thanks all. :)
 
Last edited:
Just the one which I'm afraid, we sacrificed to act as a jig while helicoiling Fays block.
That was a timing cover, and it's actually the oil pump cover he needs (memory failure on my part there) and the only one of those there was the P5B one, so still no use, but for a different reason.
 
More parts. P5B or P6B carbs/manifold. Servo's P5B or P6 four pot, for rebuild or use as exchange items. 2000 fuel pump & V8 fuel pump. Pair P6B engine mounts with good rubbers. 2000 head, water ports pretty good so good basis for recon. Four pot oil pump/pipes. Four pot water pumps, one long nose, one short nose. Both for rebuilding (I also have NOS pumps available). One PAS steering wheel for reconditioning. Early 2000 wiper mechanism (rod type). Two headlight surrounds & two D-pillar trim panels. Rear number plate plinth. Front & rear over-riders in fair condition:




Some fairly complete four-pot distributors for reconditioning or stick it on & try your luck:



Four pot engine lift bracket. P5B wood dash & front bumper blades:



P6 S2 front offside window frame with Sundym glass (etched with reg No'). Spare wheel boot support. Offside bonnet hinge:



Some grubby door pulls, any interest & I'll try & clean up to check if they're worth having. Set of S1 3500 wheel trims, nice, worth having for originality. Standard S2 wheel trims of which I probably have quite a few:



Make your offers, don't be shy. ;)
 
Last edited:
Pair of bronze kneebins, some storage marks which are getting fainter:



The passenger side back has been shortened, could be repaired if needed:

 
Last edited:
Towbars.

Two complete kits, one without the boot-brace bar. Two straight & one angled to accommodate overiders. The other hitch is one I have hanging around, able to take a tow-ring too:





I do have another couple of bars which I could have sworn I took a picture of but apparently not. I'll do it tomorrow.

Bumpers. Although they all look the same in the photo, the front one is a very nice 2000 front bar, the best one. Then another 2000, 3500 then two rears, all with various small ripples & acceptable but marked chrome. One rear has a bend as you can see:



Another pair of 2000 front bars, again chrome acceptable:

 
Towbars.

Two complete kits, one without the boot-brace bar. Two straight & one angled to accommodate overiders. The other hitch is one I have hanging around, able to take a tow-ring too:





I do have another couple of bars which I could have sworn I took a picture of but apparently not. I'll do it tomorrow.

Bumpers. Although they all look the same in the photo, the front one is a very nice 2000 front bar, the best one. Then another 2000, 3500 then two rears, all with various small ripples & acceptable but marked chrome. One rear has a bend as you can see:



Another pair of 2000 front bars, again chrome acceptable:

Dont surpose you would be willing to post a rear bumper please
Thanks tim
 
Back
Top