LT77 plastic tube - where?

jp928

jp928

Well-Known Member
I have a plastic tube from the spare LT77 - 6-7mm dia, 30-35mm long , 25+mm of it is open on one side, as though its meant to pick up oil spray and feed it out through the hollow end. Dont have my exploded diagram here now, and Rimmers diagrams arent good enough to show it...
Anybody know where it goes, have an exploded diagram please?
thanks
 
The only pipe I came across whilst in there was a steel pipe with a flattened end, which comes from the oil pump and runs along the bottom of the box. It may be a modified version of this perhaps, or just an end piece.

j101_1688.jpg

There is a plastic pipe which just covers an identification tab on the top.

Top LT77.JPG

Best exploded diagram I have for the LT77
lt77.gif
 
Found it - TKC5779L. Top bit is a breather. This one seems to be to catch oil thrown up by the primary gears and feed it through the front face into the primary pinion bearing.
tkc5779L.jpg
 
While I am here, does anybody have the size of the rear seal for a suffix A,B,C box please - or part no. Apparently they are the same until suffix D. Another site suggested 51x32, but I have a used seal here 52x32, but now unsure that it came from the suffix C box I have had apart.
thanks
 
You must log in or register to reply here.
Back
Top