1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Inner wing seals

Discussion in 'Rover P6 Bodywork & Interior' started by dmblbit, Aug 27, 2018.

  1. dmblbit

    dmblbit Active Member

    IMG_5515.jpg

    Have purchased new inner wing seals from Wins, which clip very neatly over the inner wing edges.

    Do I also need to glue them in place, or is it safe to just clip them on?
     
  2. Vern Klukas

    Vern Klukas Active Member

    You have to glue the right angle corner at the front, where you don't have the vertical section installed yet.

    Yours
    Vern
     
  3. dmblbit

    dmblbit Active Member

    Aha - that makes sense - thanks Vern.
     
  4. mrtask

    mrtask Well-Known Member

    If you don't glue the right angle corner you'll discover that the front wheels throw up more dirt and rain water than you would believe! Through even the tiniest gap between the two pieces of rubber seal! Ask me how I know! :rolleyes:
     

Share This Page