Immersion heater.

j_radcliffe

Active Member
I have been enjoying the New York Winter. The temperature has not been above freezing now for about 2 months. My Rover does not like the New York Winter. I need to start it to move it a short distance to the workshop where I am going to do some welding. Looks like I will need to used a salamander type heater to get it to run. I though it might be a good idea to install in immersion heater in the engine block, so if I have to do this again, it will not be such a problem.

Do anyone know what size thead is on the socket in the side of block, for installing a heater? I can probably match one up if I new what thread type was used.

James.
 
Back
Top