Dying seats

Not much leg room with 800 seats :D
I’m trying to find the photos of the p6 with the 75 seats in but I am not having much luck I think they have been removed but I’ll keep looking
 
Ban306 said:
With the front seats you could probably shoe horn most seats into the front however you would have to modify the fixing on the floor. With the rear seats it’s a totally different story with the front seats you can move them back and forth ect
there’s not much wiggle room with the rear seats also seat belts have to come through the seats ect I can’t say for certain the rears would fit is there any other photos of the rear seat?
Click to expand...
Morning Ban306
I was thinking more along the lines that if the 75 seats are a similar size and these seat covers fit them the covers most likely will fit my seats to smarten the originals
 
Good morning well good question the first problem I can see is the headrests do you use them? as these covers look like there design is for the spiked ended headrests
 
I was talking to a guy yesterday and he was restoring some Jaguar seats but they was leather he said he way dyeing his seats and I explained your problem about the dye coming off on your clothes. He said with the leather seats you have to use a sealer to seal over the dye to stop that from happening just an idea is there not a cloth sealer.
 
Ban306 said:
I was talking to a guy yesterday and he was restoring some Jaguar seats but they was leather he said he way dyeing his seats and I explained your problem about the dye coming off on your clothes. He said with the leather seats you have to use a sealer to seal over the dye to stop that from happening just an idea is there not a cloth sealer.
Click to expand...
I've not seen any but I only followed the instructions and they made no mention of sealer .
The head rests are on my seats but could be left uncovered being as they are same colour as covers
 
Russbus said:
I've not seen any but I only followed the instructions and they made no mention of sealer .
The head rests are on my seats but could be left uncovered being as they are same colour as covers
Click to expand...
Well I suppose you could cut a small whole in the top to make the headrests fit but your have two whole either side where the spiked headrests go, I have no idea if they would fit I would say they kinda look similar but would be impossible to tell. The dye you was using was a water dye so if it gets wet again it just rubs off have a look at Duplicolor Vinyl & Fabric spray.
 
You must log in or register to reply here.
Back
Top