(DISREGARD- LOCATED) WTB P6 v8 Engine mount brackets

Oldskoolrob

Active Member
Hi, chasing a set of V8 engine mounting brackets (block to mount) for P6B or any symmetrical mount really. Located in QLD Aus, happy to pay shipping.
 
Hi Rob,
I have a couple but it may be a while before I find them, I'm midway through moving and everything Rover is in a big heap.
Mike
 
No problem Youngskoolrob :)

PS I am stripping a V8 at the moment and hope the have the engine out soon, if you still need the mounts.
 
I did consider looking at maybe, or possibly building an electric P6, now that would be a proper Sparky, but this is a little too far gone.

Spares car
 
Ah I forgot about that one.
Considering the likely cost of the install, then yes I think a restoration on top of that would make it uneconomic to say the least.
 
@quattro @mikecoombs have either of you had a chance to get to the brackets? Turns out the set I got locally are for the early rubbers, which are near impossible to find over here. Looking for ones that suit the larger rubbers....
 
I'm still looking. I have a dose of shingles currently and am moving house...I'm down to the big pile that is going back on shelves...I hope to be back up at the shed next week.
M
 
I'm still looking. I have a dose of shingles currently and am moving house...I'm down to the big pile that is going back on shelves...I hope to be back up at the shed next week.
M
Sorry to hear that Mike! If yours are already off a car I think that would be good, to save Quattro pulling an engine just to get the mounts. I'm also following up some local avenues to see if I can get any here in Oz, so I'll follow those up first. If in the meantime you trip over a set in the pile I'll get them. They need to be the ones that fit the larger diameter rubbers. Cheers, Rob.
 
Back
Top