bulb holder on P3 headlights.

#1
Can some one with knowledge on the above lights give me the heads up on where does the guide or rudder pin on the bulb holder fit into which slot on the back of the light reflector, as i would assume it will have a bearing on the light pattern thanking you in anticipation. Derrick.Smith (deckell)P S a photo would good if possible.
 

roverp480

Active Member
#2
If I remember correctly the original bulb holder is held in with a clamp. Releasing the clamp allows the bulb to be positioned for the best focus and pattern. Its not like BPF and modern bulbs which are pre-set to give the correct focus & pattern. Is yours like this or have they been upgraded which was common improvement in the 1960's
 
#3
If I remember correctly the original bulb holder is held in with a clamp. Releasing the clamp allows the bulb to be positioned for the best focus and pattern. Its not like BPF and modern bulbs which are pre-set to give the correct focus & pattern. Is yours like this or have they been upgraded which was common improvement in the 1960's
I really don`t know for sure if they have been up graded,they have halogen globes in at the moment but i did receive some older looking globes with some spares that came wiyh the car they have a larger round glass attached to the base. thanks for your reply.
 
Top