BALL JOINT SEPARATOR/REMOVAL TOOLS - FOUND

series1

New Member
HI,
many years ago i used to make the ball joint separator part no. 601476 and bottom ball joint removal tool part no. 600962.

also a tool to fit the new bottom ball joint into the suspension leg. these were strengthened parts and would not break.
recently while clearing out the garage to move house i found 7 sets left.
i used to sell them at £60 for all 3 tools,i dont now about postage i would have to check the combined weight is about 3.5kg.
last time advertised was about sept 2000 although the address and tel.no have changed.
anyone interested please email me. i can send pics
:O :O
 
Last edited by a moderator:
I think those will be long gone by now.

Some where on this forum are the dimensions to make a splitter, if you have a lower ball joint you can make an installer fairly easily, the tool for removing the bottom joint from a pillar is a little more difficult but could be made.

I'm surprised that none of the suppliers sell used pillars with new joints fitted. That would get around the need for the puller and installer.
 
Fortunately our club down here has most of these specialized tools available....postage of an upright to and from UK would not be cheap!
 
I think those will be long gone by now.

Some where on this forum are the dimensions to make a splitter, if you have a lower ball joint you can make an installer fairly easily, the tool for removing the bottom joint from a pillar is a little more difficult but could be made.

I'm surprised that none of the suppliers sell used pillars with new joints fitted. That would get around the need for the puller and installer.

Thanks Harvey
 
Back
Top