Hello all of you.
I have zf 4hp22 which came from a jaguar. i changed the bell housing to rover type.
but there is no speedo gear on the transmission.
is it possible to convert it to mechanical speedo gear ? Or does any zf 4hp22 come with mechanical speedo gear?
Best Regard Multi
Hello all of you.
I fell over an article on facebook about edelbrock 2198 manifold which was missing two holes/passages from the water channels to the thermostat housing.
but now i am not able to find the article again.
The Rover ,Pontiac and Buick manifold would have these holes. the point is...
Can anybody tell me the exact diameter of the standard p6 crank damper . so i can make a timing tape . its a little hard to do a exact measure when it is sitting in the car.
thank you in advance, best regards. multi
Hello everyone.
I have changed the timing gear . and now i have cooling problems. the timing is spot on. i have flushed the radiator and engine. controlled top dead center. the positive stop way. it was also all right. cooking the thermostat. water seams to to be circulating. i have testet for...
Hello everybody.
I have these P6 exhaust manifolds . ( see pickture) I really like the look of them but i understand that they are a bad choice in a performance perspective.
But where are the limit? does any have some experience with them in a high performance matter? is possible to port them...
Hello everybody.
is there a smart way to remove the small core plugs located in the cylinder heads?
looking foreward to hear from you.
Best regards Multi
Hello everybody.
i have this bw 35 gearbox. which was working fine. but it was leaking badly everywhere.
so i decided to take it out of the car to change the seals.
to remove the front oil pump i had to take the valve body of. i took the pump apart to press in a new seal.
put it all together...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.