My new clutch pressure plate is not fitted with a centre thrust pad. It is of the centre finger type which I believe comes into direct contact with the clutch withdrawal sleeve. I think my withdrawal sleeve part number is571398.Is this the correct sleeve to be used with a spring ( finger) type...
My 4 speed 2000 mk2 gearbox has continued to cause problems due to a very clunky gearchange over the last couple of years.
The gearbox is now on the bench.
A full overhaul is beyond my capabilities.but I have adjusted the selectors as shown in the manual, and changed the gear change shaft bushes...
Have fitted a rebored 2200 block to my 71, 2000TC. To this, I have fitted the original 2000TC head and refurbished HIF6 carburettors. On first start up I had to churn the engine on the starter as it missed and backfired until it eventually picked up, and I was able to release the starter.
The...
My understanding, is that the engine mounting feet fitted to the TC engine block left and right are different. Whereas the feet fitted to the SC and Auto are the same. Part numbers R/S 560241 all models. And L/S on the TC only is 560242. Is that correct?
Am thinking that its probably clearance...
Am about to replace both timing chains on my 71, 2000TC. According to the WM its a seven hour job (engine installed) This means it will probably take me seven weeks. Any tips, would be greatly appreciated
George
The 2000sc engine currently fitted to my pride and joy is now showing signs of being "very tired" the grey/ blue exhaust smoke is worrying. I have tried a compression and leak down test and the results were poor, and indicating work needs to be done. The easiest option but perhaps not the best...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.