Search results

Hi anyone have a fuel pump for a 1972 3500 V8 Thanks Neil

As per title is there something on the steering wheel that cancels the indicators. Is it something that breaks and can be replaced. Thnkss

Bit the bullet and decided to change my water pump. All but two of the bolts came out. The long ones were easy as the timing cover was off last year. The two broken ones one came out with a stud extractor the other snapped closer to the cover. I managed to drill it down the centre. With a bit of...

Anyone know best place to get a rear valance from? Thanks

Should speedo be lubricated if so with what.

Hi all while out on a drive yesterday my speedo stopped again. I replaced the angle drive last year as the previous had it replaced also but it wasn't fitted well. I have done just 400 miles and it s stopped. Is there something I am missing?

Just thought I would share a few photos of mine at shows.

What have I done. I fitted fog lights and wired in as per instructions I found on here. But now I don't have any headlights. I have disconnected the wiring to the lamps but still nothing. The headlamp flash works. Side lights work but no dipped or main beam from switch. Also notice no panel...

Hi anyone have right hand rear wing for series 2 Corsica blue would be amazing.

Not sure what to do about this. The switch operates but lights don't flash. However if the hazard switch is on it cuts out normal indicators. I have replaced both flasher units. Is there a fuse for hazard lamps. I am stumped as to what to try next. Anyone had similar problem. Thanks in advance...

Which fuse for hazard warning lights please. I cant see from diagrams. Thanks Neil

Hi this is me with my series 2. It was a great turnout with at least 12 more P6's around. I was next to CliveP62 and his dad with their stunning white one.

Which carb serves which cylinders please.

Hi have just replaced cooling fan that was missing on the advice of Clivep62. Also 4 new tyres to replace badly perished ones. Now need to take for a little run to see if it improves fuel evaporation. May need water pump also as detected a little play now fan is fitted. Slowly putting it right...

does anyone know if I could have a second electric pump running continuous with mechanical pump. Thanks.

After completing refurb of carbs ignition and camshaft and followers plus timing chain I am still having running problems. I am now contemplating removing cylinder heads to check valves. There is a popping noise in the exhaust note. Anyone else had similar problems.

What should I use to lube new camshaft and followers. Thanks

Hi I have just checked resistance of coil (Lucas DLB110). Its 1.5 ohm on LT side 8.43 on HT side. I believe HT side is a bit low as it should be around 10. Can anyone confirm. If this is at fault may be the answer to my running problems. Thanks Neil

Are there going to be any members going to above. Its not far from me so may well go. Not sure whether I will get to bottom of running issues before though.

Would car run if timing 180 degrees out? I m just wondering if this is my case.

Still can not get to bottom of this poor running. After suggestions removed carbs stripped and cleaned them. Now it will only run badly with choke out. I need help if possible. Is anyone close to me who would be able to cast their eye over to see where I am going wrong. Also I did notice air...

I have gone through and managed to get car running better. However I still cannot get it to rev over 2000 rpm and then it rises and falls. To get this far I have reset points gap which improved it greatly, reset timing to 6 degrees btdc as per manual. When I try to set 2,4,6,8 carb nothing...

Hi I have a terrible misfire now. I had fitted accuspark electronic ignition kit. It ran well to start with. The timing seems all over the place. It seems to be running rich. I have changed plugs and have spark at all cylinders checked with spark testers. Any one have any ideas. Thanks Neil

Hi I am after a timing cover so I can have it modified to take later seal. Thanks Neil

I have a problem where the car will only start in neutral. Could this be down to adjustment of the switch or gear lever. Any ideas welcome.