Search results

I have a problem with my manual steering box. I have been replacing seeping gaskets and accidently push the drop arm causing ball bearings to drop out of place. I have stripped the box and am about to rebuild it. I cleaned and counted the ball bearings to make sure I did not lose any. I was very...

Hi, I am looking at fitting a ZF 4HP22 Sherpa gearbox to my 3500 Auto. Most of the issues and "how to" are covered on other posts. I want to keep the mechanical speedometer drive of the Sherpa tail. One idea I have is to alter a BW65 speedometer adaptor. I have access to a machine shop to...

Hi, I am working on a vented disc conversion for my '74 3500 Auto. I have dismantled the front hub assembly and compared it with the workshop manual. I appear to be missing the inner bearing spacer, item 2 on the attached page from the workshop manual. Is this bearing spacer fitted to all P6's...

Hi, I'm tracing wires to the coil on my 1974 3500 Auto before I fit electronic ignition. I have the two white/black wires to the distributor and tach on one side of the coil and two white/yellow wires (one thicker than the other) on the other side which I assume are the feed from the starter...

Hi , Just starting to put the car back together after chasing rust. The car is a S2 3500 Auto. The rear bumper irons have an offset. Forgot to take a photo. Which way does the offset go - to the outside or to the inside? Thanks KJ

HI, Been a member for a while so I thought it was time to introduce myself. I have owned GWEN for over four years now. She is a 1974 3500 auto in Almond. (photos attached) Having not much to do during shielding and the cold weather stopping work on the car (no garage) I started to try and solve...