Search results

  1. R

    Outer sill covers

    Anyone with sill covers?
  2. R

    interior wanted

    Could you send me pictures then I can have a look at courier etc I did have a contact for a man in van who would collect most sized things, didn’t need to be palleted
  3. R

    interior wanted

    Any idea what courier would be on an interior?
  4. R

    interior wanted

    How far away are you guys?
  5. R

    interior wanted

    I’m in Kirkcaldy, Fife. Black would be fine, I think the car originally had black and it’s been changed for dark tan colour which looks like it’s had a poor job done on it previously
  6. R

    interior wanted

    interior roof light aswell
  7. R

    interior wanted

    also could do with a good interior if anyone has one going, my seats look a bit tired and someone has put a speaker in each glove box cover which looks terrible
  8. R

    Outer sill covers

    kirkcaldy fife, that would be great, what would the cost be? thanks
  9. R

    Outer sill covers

    Hi Need 2 sill covers, don’t mind some flaky rust will refurb them
  10. R

    Wanted P6

    I am looking for a nice p6, prefer 3500, I have a 1978 Daimler 4.2 Series 2 in very nice condition, only done 36000 miles, would do a deal with it in a swap or px Lots of images available Call or message 07866847572
  11. R

    Borg Warner 35 problems?

    Stumbled across this post as I also have bw 35 issues, I've had many British classics with this box and never had a problem, 3 p6 v8's, now it's a princess 2200 Auto, did very similar things like change fluid etc but never made a difference, I drove the car round housing estate and on way back I...
  12. R

    New project 74 3500

    Tried different condensers and coil but same scenario, the test lamp illumanates slightly brighter on the wire when off the coil than testing it when attached onto coil lug on + side, normal or iffy connections? For all the work I've done I've hardly touched any connections or wiring really...
  13. R

    New project 74 3500

    update, not had much time recently but back to rover in past few days, put in new points and condenser but now I have no spark, on testing the coil I have a live at + side not on both, tried another coil (not new but I have a new one coming) same thing, no spark at points when turning over...
  14. R

    New project 74 3500

    got the inlet manifold cleaned up, carbs stripped and cleaned as good as I can etc and top of the cylinder head cleaned in situ, another oil change and runs a lot quieter with no tappet noise, but now still runs lump and wont rev past 2000rpm without wanting to choke up and cut out (does not rev...
  15. R

    New project 74 3500

    quick update, got manifold off and had a look at camshaft, tried to get a good pic of lobes in place to check condition but not the easiest thing to do lol tappet looks clean and even, no bad markings or obvious bad wear so I am sending radiator away for cleaning and check, it seems a bit damp...
  16. R

    New project 74 3500

    sorry forgetting about the tappets being hydraulic, will it be best to get heads cleaned first and sump, then see if that makes a difference to running before digging into camshaft? it looks like its not had very many miles, done looking around it and interior etc, just not had very many oil...
  17. R

    New project 74 3500

    Hi I have recently bought a 74 3500, TUC 272M apparently a genuine 46000 miles, White been in storage for years, got it started but runs lumpy and sounds like misfire, oil change new plugs made a small difference, it's does idle without wanting to cut out and starts relatively easy, not smokey...
  18. R

    1976 2200TC for sale (based in Glasgow)

    hi, is this for sale still? I'm in Kirkcaldy, Fife not too far
  19. R

    new project 2000TC

    Finally managed to get another p6 again, this requires alot of work to body and theres an unusual engine issue, previous owner did head gasket but didnt put shims back in same places so runs very badly, so im told No pics yet but will do soon
  20. R

    Couple of badges, gear gaitor, radio cover/blanking plate

    I have 3 2000 wing/boot badges in good condition with pins intact also have 1 2200sc wing/boot badge good condition with pins intact Gear lever rubber gaitor which has small tear near bottom (will add photos) Radio blanking plate in really good condition with hardly a mark on it and badge with...
  21. R

    Rover p6 v8

    I have a mk2 1975 triumph stag resto project, I am wanting a p6 project/runner instead, rather have a saloon car, The stag needs welding to usual areas, has a new boot floor welded in, interior all there with factory hard top requires resto, rag top in really good condition, been off road for...
  22. R

    vanden plas 1300

    im finding it hard to find one close buy of any kind at the moment, even looking further afield isnt coming up with much would really like one again though, maybe i would prefer a manual rather than an auto though
  23. R

    vanden plas 1300

    thanks very much the 2 p6s ive had have been v8s so i havent driven any other engine in a p6, ive read the 2200tc drives better than the v8s but as long as the car was ok i wouldnt mind
  24. R

    vanden plas 1300

    i have had quite a gap between doing cars up recently, i like to dabble and sort old cars and once i have sorted them i kind of loose some of the interest in them but i like to have a varied choice of car or uncommon old cars, but now i have a 3 week old son i will not have the time to dabble as...
  25. R

    vanden plas 1300

    well to assume i am dealer is rather unfair because the plates actually belong to my work so i am not a dealer and as if this would make a difference to the sale of the vehicle
Back
Top