Search results

Hi, As far as I know a lot of people have used the LT77 5 speed box out of later British Leyland vehicles. This is mainly as it is a much stronger box and gives better motorway cruising abilities. I have a 1968 auto that has been converted using this box. I find it a bit agricultural until it's...

I think it is over priced based on the photos. It looks quite rusty around the air intake. Might hide nightmares within just like my own box.

Thanks I'll have a wee look.

Good morning all P6 fans. A shot in the dark here. Would anyone have a usable heater box for sale? Mine is toast. It is rotten around the fresh air intake which allows water to gather in the bottom of the box. This has led to the bottom rotting through. Grrrr!! I'm on the isle of wight.

Yes it was PeterZRR.

I was lucky a local motor factors had one in stock.

Thank you all for tips & advice. It turns out that it was a faulty temp sensor. Fitted a new one this morning and for a quick trip out the temp gauge needle stayed bang in the middle of the gauge. One happy boy. Next job try to fix the non working heater fan and fitting aldon electronic...

Thanks Harvey6 I checked that tiny hose when I did all the flushing. It's running very well.

Good afternoon all. My P6 3500 looks to be overheating according to the temp gauge. It hovers around the end of the green section bordering the red. Previously it hovered near the white section hardly touching the green section. So far I have put a new 82 degree thermostat in, taken the...

Cheers.

Thank you

Good Morning and happy New year Rover fans. I might be in need of a new battery for my 3500. Currently it has a Yuasa HSB 075. It doesn't seem to be tall enough as a previous owner has put blocks of wood in the bottom of the battery box. This may be to vent the battery via the large drain hole...

Yes, I have checked the carb tower hose and it is hot when car is up to temperature. Many thanks.

Can I ask what electric fuel pump did you use?

Hi, I used 3500s manifolds on my series 1. I purchased new ones from JR Wadhams. I purchased a stainless steel exhaust from PD Gough. It fitted excellently. Good luck.

That's great thanks.

Hi all, the problem is that the clutch fluid is cooking and starts to fade quickly. When I depress the clutch and engage gear the car starts to move even before I start to take my foot off the clutch. Once on the move it seems ok. The system has been bled several times but the fluid comes out...

Hi, I have bought a 3500 auto that has been converted to 5 speed. However, the install is a bit of a "dogs dinner" and the heat shield for the brake master cylinder is resting on the exhaust manifold to fit an unknown clutch master cylinder next to it.If I am unable to source 3500S parts or left...