Search results

  1. stevewilliams

    Fuel Filter

    I'm trying to replace the fuel filter, it came with two nuts and olives, although I've no idea how to fit the nuts past the pipes on the filter? Brut force? Any advice would be much appreciated.
  2. stevewilliams

    Leaking reserve tap

    Thanks guys, most helpful, will have a go today.
  3. stevewilliams

    Leaking reserve tap

    I'm about to replace my O ring too, engine is out but no idea where the O ring goes? Any advice appreciated.
  4. stevewilliams

    Throttle linkage HIF 6 Carbs

    Thanks for the advice everyone. Managed it in the end, it was the seal cap on the starter spindle which was fouling the spring, didn't notice this at first, all sorted. Both carbs done.
  5. stevewilliams

    Throttle linkage HIF 6 Carbs

    HI, Having an enormous problem after servicing my HIF 6 carbs for my 3500. Working my way through, using the manual and the instructions with the service kit, all went well until I tried to refit the camb return spring. It just refuses to sit right and is trying to escape. I've located each end...
  6. stevewilliams

    Front Wing

    Hi, I'm after a front drivers side wing for my 3500, preferably Cameron Green in colour, although any other colour will do.
  7. stevewilliams

    Auto box removal

    Just taken the engine out of my 72 3500 without the gearbox, bit of a fiddle but does come out.
  8. stevewilliams

    Recolouring seats

    Hi, I'm embarking on an interior colour swap from bronze to black and have acquired some buckskin coloured seats as mine are falling apart. Obviously the seats are part leather, part vinyl. I was going to dye the seats with a furniture clinic kit and recolour the vinyl parts with a black vinyl...
  9. stevewilliams

    Engine out tasks?

    Hopefully will have out in a few weeks and see what's what. Don't know the condition/history of the engine really. Had the car for a few years now and took it off the road due to low oil pressure and never got round to sorting it.
  10. stevewilliams

    Engine out tasks?

    Hi Ron, Yes, crankshaft and camshaft. I thinking of replacing all hoses whilst engine out as a matter of course, hadn't though bout the o ring though. The car suffers incredibly low oil pressure, once warm, it doesn't really register on the gauge and the light flickers whilst idling, hence the...
  11. stevewilliams

    Rover P6 Rear Panels

    I managed to weld in a new D post and didn't find it too trick as a newbie welder. Careful measuring and cutting is the key..
  12. stevewilliams

    Engine out tasks?

    Hi, I'm just about to embark on taking the engine out for bearing replacement. This is the first time I've taken a car engine out since 1988! What other tasks/maintenance would be wise to undertake whilst the engine is out. I also plan to tidy the engine bay and replace the knackered electric...
  13. stevewilliams

    High Capacity Oil Pump

    Cheers for the info.
  14. stevewilliams

    High Capacity Oil Pump

    Will the running clearance be something I’d need to do, or should the pump come set up?
  15. stevewilliams

    Removal of roof gutter trims

    How do they come off, slide off?
  16. stevewilliams

    Removal of roof gutter trims

    Is it possibly to remove the gutter trims without removing the roof panel?
  17. stevewilliams

    High Capacity Oil Pump

    Does the fitting of a high capacity oil pump put increased starin on the engine?
  18. stevewilliams

    SD1 wheel trims

    Ok, cheers Harvey.
  19. stevewilliams

    SD1 wheel trims

    Hi, do any of the SD1 wheel trims fit P6 wheels?
  20. stevewilliams

    Engine removal without removing auto box

    Damian, Thanks, that's a great help. Hopefully make a start in a week or so...….. Cheers.
  21. stevewilliams

    Engine removal without removing auto box

    Think I may have asked this before but after much stalling etc, finally about to take the engine out, seeing as I've time on my hands due to lockdown.... Crane and engine stand standing by. Question is, is it possible/easy to take the engine out without the auto gearbox? Ex mechanic mate of...
  22. stevewilliams

    Ebony trim required

    Hi joseph, I'm after the rear trim above the parcel shelf and b and c pillar rim.
  23. stevewilliams

    Ebony trim required

    Hi, I'm after any ebony trim as I'm hoping to change my interior colour. Mainly after C/D post trim, rear trim above parcel shelf and door cards.
  24. stevewilliams

    Ebony trim required

    Hi, I'm changing my interior trim colour to black. Would anyone have any black trim they want to sell? Looking for B Post trims and the rear parcel shelf trim. Cheers
Top