Hi all
After a 6 year hiatus, the Elegant Thirsty Dinosaur is back in my sights! The ETD is my 1975 3500 Auto, PAS - an NZ assembled car we`ve owned for 19 years now.
After my last major renovation back in 2011 / 12 the car was on the road continuously from 2012 through to 2019. Sadly, it...
Hi Ron. Thanks very much for the information and wow that is rather expensive.
I may have to see if I can find something 2nd hand down here.
Cheers
James
Hi Ron. I'm currently having the same problem with my oil pressure. Intermittently dropping to zero on the gauge. No oil warning light and no knocking from the engine. I`m sure it is the sender. I tightened the spade clip on the sender itself. no change.
Do you know what the correct sender...
Thanks for all your help everyone. I finally found the smoking gun with my ignition issue tonight, I think.
There is a fuse on the ignition circuit, labelled 19 / 20. I discovered I was able to make the engine cut out by jiggling the fuse around. This fuse is adjacent to the headlight fuses on...
Well, it appears to be the accuspark module dying. The fault seems to be on the -ve side of the coil. Waiting on a new one from Simon bbc.
To add to my woes, now the front driver`s side brake caliper is leaking! No rest for the wicked..
Thanks Peter. I found this : http://www.vintagemodelairplane.com/pages/Downloads/Rover_PDFs/IntermittentIgnition01.pdf , this looks like a useful diagnostic tool for whether the fault is up or downstream of the coil itself.
I`ve cleaned up all the connectors and tightened them all up...
Thanks guys for your comments.
Roverp480 , thanks for the information regarding the circuit feeding the low tension side. I`m surprised there`s no fuse. I would have thought there would be some protection for a short in the coil or similar. The ignition light stayed off when the hesitations...
Hi. My usually reliable Elegant Thirsty Dinosaur (75 3500) has started misbehaving following a bit of a lay-up. It was off the road for about 9 months. Now, there is an intermittent fault with the ignition. Large hesitations occur. They are abrupt and the tachometer jumps down to zero and back...
Thanks for all the responses. Sorry for my slow reply - I had forgotten posting this.
With main beam switched on, just the inners are lit. Flashing the mains by pulling back on the stalk turns on all four. So main on the outers is not working.
I converted the inners to halogen replacements...
A question for you all.
When you switch to main beam (rather than just flash the lights) , should all 4 lamps be on?
On my car, all four are on when I flash, but just two when I switch to main beam.
Thanks
Cutting out at the lights sounds like it might be fueling related to me. I would recommend looking for vacuum leaks and a check of float levels and carb balance before panicking about the timing. Especially with the low mileage, I can`t imagine the chain would be too bad.
Thanks for the link, but that one is listed as not to fit the 3500.
The threaded ferrule that should lock into the hole in the dash is too small. I found a 'universal' one on a Mini parts site and that didn`t fit either.
Incidentally getting parts from the UK Is actually not too bad. As long...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.