george cook's latest activity

  • G
    george cook replied to the thread Clutch Pressure Plate.
    The photographs were excellent.Looking at those it's pretty straighforward.My withdrawal sleeve is the larger diameter curved type...
  • G
    george cook replied to the thread Clutch Pressure Plate.
    The clutch which I replaced was fitted with a centre pad. The replacement fitted had no centre pad but straight fingers. I have not...
  • G
    My new clutch pressure plate is not fitted with a centre thrust pad. It is of the centre finger type which I believe comes into direct...
  • G
    george cook replied to the thread Selector Lever.
    Tend to think it's general wear, but .I believe reshaping that worn selector finger should help a lot. The rear flange nut, was...
  • G
    george cook replied to the thread Selector Lever.
    With the gearbox on the bench, that's exactly what I would like to do.Thanks Regards George
  • G
    george cook replied to the thread Selector Lever.
    Thanks Vern My selector finger is the latest type held with a pin. I was hoping to rebuild my existing worn finger if possible, but if...
  • G
    My 4 speed 2000 mk2 gearbox has continued to cause problems due to a very clunky gearchange over the last couple of years. The gearbox...
Back
Top