Recent content by finfont

  1. F

    Distributor Rebuild

    Good news!
  2. F

    Distributor Rebuild

    You might try Martin at Distributor Doctor. He should have the correct points.
  3. F

    Distributor Rebuild

    Will give it a try. Many thanks!
  4. F

    Distributor Rebuild

    I'm interested in your idea. The points base is seated correctly. It is the type of points set without a secondary pin to seat in the base plate. My mechanical background is limited, but, I'd like to learn. How would I determine of the vacuum advance peg is properly connected? Thanks, Drew
  5. F

    Rear Brakes/Discs

    Point taken.
  6. F

    Rear Brakes/Discs

    Well, I'll definitely check the measurements and skim them if appropriate. As far the "Harvey Test", I may save that for another time :))
  7. F

    Rear Brakes/Discs

    Thanks, Harvey. I'll give it a go.
  8. F

    Rear Brakes/Discs

    Harvey- That's pretty much similar to the service manual directions, is it not? Also, when you say to place the stands under the "base unit", what exactly are you speaking of? Thanks, again. Drew
  9. F

    Rear Brakes/Discs

    I'm fixing to change out the rear brake pads and discs ( Rover P6, 3500 Automatic, 1972). I have seen a post where the project is approached from the side of the car initially. The rear wheel is removed, and, then, the final drive is disconnected, allowing access to the disk and brakes. It...
  10. F

    Distributor Rebuild

    No, the dwell is set and stable. And, yes, the distributor functions perfectly fine, but, only, after I've "adjusted!) the heel so that it contacts the cam. I do plan on sending it off, but, I don't relish the thought of not being able to use the car for those 3 - 4 weeks. So, at this point...
  11. F

    Distributor Rebuild

    Peter- I know, I checked on line. They do seem to be available. I'm not sure what to believe at this point. Thanks,
  12. F

    Distributor Rebuild

    Peter- Just contacted a well-known distributor man about the Mallory. He replied, "They are a dead brand, with no support." Thought I'd pass that along. Again, your input is very much appreciated. Drew
  13. F

    Distributor Rebuild

    Peter- You give me far too much credit for knowledge of mechanics. I wasn't aware of these units. I will look into them. Thank you.
  14. F

    Distributor Rebuild

    Finding someone on this side of the Atlantic that can work on these fussy old cars is a rare treat. I will contact him today. Thank you, Jim.
  15. F

    Distributor Rebuild

    Morning, all: Re: 1972 P6 3500, Automatic: I'm having a difficult time fitting contact points ( the correct ones, and, of good quality) on my distributor. The heel doesn't contact the distributor cam as it should. I'm thinking it's time to rebuild the distributor. Is this a project that...
Top