Recent content by Carlos

Thanks Cobraboy. Quite true the they are different...but both are valve piston rubber seals. I would say comparing oranges and tangerines...:hmm:

Thanks Ron. I thought that maybe changing the position of the rubber seal, could help the piston not to stick in the bore. But for sure that could cause the fluid to leak.

Sorry to bother you, but I have another question: I took off the tiny piston in the air valve. The piston comes with only one rubber seal, as you can see in the photo. Is the seal installed correctly or has to be installed the other way ? In another forum ( Landcrab ), the piston is in the...

Thanks Ron, that explains why some booster didn't come with the big spring. I've sourced one from a garage and will install it.

With Brexit, everything coming from UK costs a lot, money and time...:rolleyes:

Thanks Colin for your interest. I read this thread in the Lotus forum and apart the comment about removing one of the o rings, I found a picture where I can see clearly the big spring that I missing.

When I made the servo, I bought the complete kit: big 7"diaphragm, complete slave cylinder kit, and air valve kit ( white cap, filter, rubber diaphragm but no big spring ). Wins, Wadhams and MGBD doesn't seem to have it. I will try to build one with a soft spring and see what happens.

The same happens with my servo. It comes without the big spring

Thanks for your answer. As you see, some valves have the big spring and some doesn't. I will try to build one; maybe cutting the soft spring inside the SU carburetors. With the Brexit, getting parts from England became a little nightmare and takes ages.

Thanks Cobraboy but I'm talking about a bigger spring that should be under the white cap, between the cap and the rubber diaphragm.

Thanks for your feedback ! The problem is that again, in the Big Workshop Manual ( and in my valve ), the spring doesn't exists. ( see photo ) And there is no spring in the kit.

Dear people, first of all excuse my English. I´m into the final process of fixing the brakes of a 1976 Rover P6 2200 TC, that belongs to a friend of mine. I´ve made everything: - rear calipers kit ( late Girlin ) quite complicated but accomplished thanks to Mark Gray´s video. - front calipers...

Well ...almost above, the wall in the back is part of the pool. And in the patio , with bad company, we play with other British oddities.

I found it very straightforward, despite I've had a couple of problems. The main one was that I've lost most of the photos of the disassembly. Its very important to take lots of pictures during this process. For me it´s essential: - Good tools. I mean not a pro garage, but the essentials ( a...

Thanks JP, it was a nice experience.